User manual

22
CLLLUKE700RGB / CLLLUKE1000RGB System Settings - terms and explanations
Display ON = Display light is permanently on
OFF = Display light is permanently off
5S = Display light turns off after 5 seconds of inactivity
15S = Display light turns off after 15 seconds of inactivity
Master ON = Master/Slave mode: DMX signals will be output
OFF = Master/Slave mode: DMX signals will not be output
Note on the master/slave mode: Master unit: Master ON
Slave unit: 4-CH Mode
Laser Size 10 - 128 = Setting the maximum size of the laser projection
Colour = RGB = entire colour spectrum. RGY = red, green and yellow.
InvertX ON = Movement direction of the X-axis is reversed
InvertX OFF = Standard movement direction of the X-axis
InvertY ON = Movement direction of the Y-axis is reversed
InvertY OFF = Standard movement direction of the Y-axis
Default = Reset to factory setting
Test Pattern = Test projection and setting the speed of stepper motors
from 10Kpps to 30Kpps (Kilo points per second)
CLLLUKE400RGY System Settings menu
Setup ENTER -> UP/DOWN Display ENTER -> UP/DOWN ON
OFF
5S
15S
Master ENTER -> UP/DOWN ON
OFF
Laser ENTER -> UP/DOWN Size ENTER -> UP/DOWN Size 10 - 128
InvertX ENTER -> UP/DOWN ON
OFF
InvertY ENTER -> UP/DOWN ON
OFF
Default ENTER
Test Pattern ENTER -> UP/DOWN Scanner 10 - 30KPPS