User Manual

Cameo D4 / Other Information
56
Read : takes the show from the device and loads it into Cameo D4. Note that on devices with
limited memory, only essential information is saved therefore reading the memory should only be
used if the .dvc file has been lost. For example, scene names may not be recalled.
Test : sets the DMX interface to Stand Alone mode allowing for the Stand Alone show to be tested.
Clear Memory : erases all written scenes from the memory. Note that each time the memory is
written, it is erased first and therefore it is not necessary to clear the memory before writing a new
file.
Port Triggering, Jumping and Looping
Scenes can be triggered via the DMX interface’s dry contact ports. The port is set within the scene properties window of the Edit
tab. See the ‘Dry Contact Ports’ topic for more information.
A scene can be set to loop a certain number of times and then jump to another scene. These settings can be found within the
scene properties window of the Edit tab.