User Manual

8
DMX
ITALIANO
POLSKI
ESPAÑOL
FRANCAIS
DEUTSCHENGLISH
ADVANCED SETTINGS
Press MODE to access the selection menu (System Settings). Using the UP and DOWN controls, select the menu item “Advanced Settings”
(dark background) and confirm with ENTER. This will take you to the submenu for editing the following submenu items (see table, selection
with UP and DOWN, confirm with ENTER, change status/value with UP and DOWN, confirm with ENTER):
Advanced settings (bold = factory setting)
Display Invert = Display rotation No No display rotation
Yes Rotate display by 180°
(e.g. for overhead installation)
Display = Display lighting On on permanently
30s Deactivates after approximately 30 seconds of inactivity
Display
Contrast
= 3-stage contrast setting 0 low contrast
50 medium contrast
100 high contrast
DMX Fail = Operating status in the
event of
DMX signal interruption
Hold Last command is retained
Black Activates blackout
LED Calibra-
tion
= Cross-mode calibration of the
R, G, B and W brightness
Red 000–255 calibrate red
Green 000–255 calibrate green
Blue 000–255 calibrate blue
White 000–255 calibrate white
Factory Reset = Reset to factory settings No Do not perform reset
Yes Perform reset
System Settings
DMX Address 001
DMX Mode 7CH_2
Stand Alone
Slave Mode Off/On
Advanced Settings
System Info
Advanced Settings
Display Invert No/Yes
Display 30s/On
Display Contrast 0/50/100
DMX Fail Black/Hold
LED Calibration
Factory Reset
DEVICE INFORMATION
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item “System Info” (dark background) and
confirm with ENTER.
System Settings
DMX Address 001
DMX Mode 7CH_2
Stand Alone
Slave Mode Off/On
Advanced Settings
System Info
System Info
Version
Temperature
Hours
This will take you to the sub-menu for displaying device information. Use the UP and DOWN keys again to select the desired parameter and
then retrieve and/or configure with ENTER.
System Info (bold = factory setting)
Version = Displays device software version V1.x
Temperature = Displays temperature of LED unit Temperature xx°C/xx°F
Unit °C/°F Display in degrees Celsius or degrees
Fahrenheit
Hours = Operating time display xxxxx Displays the operating time of the spotlight
in hours