User Manual

7
DMX
DEUTSCHFRANCAIS
ESPAÑOL
ENGLISH
ITALIANO POLSKI
SETTING STANDALONE MODE
Six different stand-alone operating modes are available. Press MODE to access the selection menu (System Settings). Using the UP and
DOWN buttons, select the menu item “Stand Alone” (dark background) and confirm with ENTER. Using the UP and DOWN buttons, select the
desired stand-alone mode and confirm with ENTER. Please refer to the editing options of the individual stand-alone modes in the following
table. Use UP and DOWN to select the desired parameter, ENTER to enable editing, UP and DOWN to change the relevant value, and ENTER
to confirm.
System Settings
DMX Address 001
DMX Mode 7CH_2
Stand Alone
Slave Mode Off/On
Advanced Settings
System Info
Stand Alone
Colour Macro
Sound 00–99
User Colour
Fade
Jump
Auto
Stand Alone
Colour Macro Red, Amber, Yellow Warm, Yellow, Green,
Turquoise, Cyan, Blue, Lavender, Mauve,
Magenta, Pink, Warm White, White,
Cold White
Red
–
Cold White
Sound
(music control, colour = colour
macro)
Sensitivity = microphone sensitivity 00–99
User Colour
(individual colour blend + strobe)
Dimmer 000–255
Strobe (000–010 = no function,
011–255 = approx. 1–30 Hz)
000–255
Red 000–255
Green 000–255
Blue 000–255
White 000–255
Fade
(alpha blending)
Speed 000–100
Brightness 000–100
Jump
(colour change)
Speed 000–100
Brightness 000–100
Auto
(combination of
colour blending, colour change,
strobe)
Speed 000–100
Brightness 000–100
SLAVE MODE
Press MODE to access the selection menu (System Settings). Using the UP and DOWN buttons, select the menu item “Slave Mode” (dark
background) and confirm with ENTER. The status field will display “On”. Press MODE to return to the main display. After about 30 seconds
of inactivity, the main display is automatically activated and “SLAVE” is clearly shown in the centre of the display. Connect the slave and the
master units (same model and software) with a DMX cable and enable one of the stand-alone modes on the master unit. The slave unit will
now follow the master unit. As soon as you activate one of the other operating modes, the slave mode status field will automatically display
“Off”. The control signal from the master unit is only transmitted if the main display is activated in the master unit. The main display must
also be activated on the slave unit.
System Settings
DMX Address 001
DMX Mode 7CH_2
Stand Alone
Slave Mode Off/On
Advanced Settings
System Info
Operating Mode
SLAVE