Operation Manual

11
DMX
DEUTSCHFRANCAIS
ESPAÑOL
ENGLISH
ITALIANO POLSKI
Dimmer Response = Dimmer sensitivity LED Lamp responds abruptly to changes in DMX value
Halogen Lamp behaves like a halogen spotlight with soft bright-
ness changes
Color Calibration = Color calibration
(If one of the DMX factory
calibration modes is activated,
no other calibration can be
selected and the message
“no possible change in this
DMX Mode” will be shown
on the display. If one of the
DMX user calibration modes
is activated, RAW can be
selected as the alternative
calibration.)
RAW individual color calibration. Brightness adjustment of 4
RGBW LED groups for all modes in the range 000-255
User calibration Individual color calibration. Cross-mode brightness
setting of the 4 LED groups RGBW with values from
000 - 255
Factory calibration Factory-default calibration of R, G, B, and W (across all
operating modes). Select this setting to ensure the con-
sistent-looking presentation of color macros in stand-
alone mode and to control color macros with DMX.
Autolock = Automatic locking of the
controls
On Automatic locking of the controls after approximately 1
minute of inactivity. Display shown upon attempted use:
“Locked!"
To unlock: Press and hold UP and DOWN simultaneously
for approx. 5 seconds
Off Automatic locking of the controls is disabled
LED Frequency = LED PWM frequency 800Hz / 1200Hz /
2000Hz / 3600Hz /
12kHz / 25kHz
Configuration of LED PWM frequency
IR Remote = Activate or deactivate control
by IR remote control
On IR remote control activated
Off IR remote control deactivated
Fan = Adjusts fan speed Auto Automatic fan speed control
Max Intensity Maximum fan power for maximum brightness
Low Noise deactivated fans with reduced brightness
Factory Reset = Reset to factory settings Reset Now! Reset to factory settings:
Confirm with ENTER. Cancel with MODE
linear
DMX value
Light intensity
exponential
DMX value
Light intensity
logarithmic
DMX value
Light intensity
S-curve
DMX value
Light intensity
Dimmer curves
SYSTEM INFORMATION (System Info)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "System Info" (observe arrow) and
confirm with ENTER.
------------------- Menu ---------
----------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
Use the UP and DOWN controls to select the desired submenu item, and press ENTER to display the corresponding information.