User Manual

12
Basic Setting
This is the page allow user to change the access point settings.
.
AP Name: The name of the AP, which can be used to identify the Access Point
among the all the Access Points in the wireless network.
SSID: Service Set Identifier, which is a unique name shared among all clients and
nodes in a wireless network. The SSID must be identical for each clients and nodes
in the wireless network.
Channel: The channel that AP will operate in. User can select the channel range
from 1 to 11 when AP set in North America (FCC) domain. User can select the
channel range from 1 to 13 when AP set in European (ETSI) domain. And User can
select the channel range from 1 to 14 when AP set in Japanese domain.(User can’t
change the setting of domain.)
Extended Range: When you enable this function, AP will reduce data rate with a
long distance.
Authentication Type: There are four options: Disable, WEP, WPA and WPA2. All
of the WLAN nodes and hosts on the network must use the same authentication
type.
WEP Key:
1. Key type: Select the WEP key type for Open System or Shared Key; the
Open System allows public access to the AP via wireless communications;
the Shared Key requires the user to set a WEP key to exchange data with
other wireless clients that have the same WEP key.
2. WEP Key length: Select the WEP key length for 64bits or 128 bits.
3. Key mode: Select the WEP key format for ASCII or HEX.
4. Key 1 ~ Key 4: Specify the WEP key value in key 1 ~ key 4.