User's Manual

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20cm is maintained between the

antenna and user. 2) The transmitter module may not be co-located with any other transmitter or

antenna. 3) The module is approved using the FCC’ unlicensed modular transmitter approval’ method.

Therefore the module must only be used with the originally approved antennas.

s long as the 3 conditions above are met, further transmitter testing will not be required. However,

the OEM integrator is still responsible for testing their end-product for any additional compliance

requirements required with this module installed (for example, digital device emissions, PC peripheral

requirements, etc.)

IMPORTANT NOTE: in the event that these conditions can not be met (for example certain laptop

configurations or co-location with another transmitter), then the FCC authorization is no longer

considered valid and the FCC ID can not be used on the final product, in these circumstances, the

OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and

obtaining a separate FCC authorization.

End product labeling

This transmitter module is authorized only for use in device where the antenna may be installed such

that 20cm may be maintained between the antenna and users. The final end product must be labeled

in a visible area with the following: “Contains TX FCC ID: NHPWLG1303”.

Manual information that must be included

The OEM integrator has to be aware not to provide information to the end user regarding how to install

or remove this RF module in the users manual of the end product which integrate this module.

The users manual for OEM integrators must include the following information in a prominent location

“IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used

for this transmitter must be installed to provide a separation distance of at least 20cm from all persons

and must not be co-located or operating in conjunction with any other antenna or transmitter.