User's Manual

WIRELESS BROADBAND ROUTER CONFIGURATION

First make sure that the network connections are functioning normally.

This Wireless Broadband Router can be configured using Internet

Explorer 4.0 or newer web browser versions.

Before configuring the Wireless Broadband Router through WLAN, make

sure that the SSID, Channel and the WEP is set properly.

The default setting of the Wireless Broadband Router that you will use:

SSID: default

Channel: 6

WEP Encryption: disable

Before you configure this device, note that when the Wireless Broadband

Router is configured through an Ethernet connection, make sure the host

PC must be set on the IP subnetwork that can be accessed by the

xDSL/Cable modem. For example, when the default network address of

the xDSL/Cable modem Ethernet interface is 192.168.1.x, then the host

PC should be set at 192.168.1.xxx (where xxx is a number between 2 and

254), and the default subnet mask is 255.255.255.0.

Using the Web Browser

1. Open Internet Explorer 4.0 or above Internet browser.

2. Enter IP address http://192.168.1.1 (the factory-default IP address

setting) to the URL web address location.