User's Manual

14

Data Rate: to select the transfer rate from 11, 5.5, 2, 1Mbps and
Auto.

Preamble Type: to limit the packet size of the data to transmit.
It is recommended to choose the short preamble when the link
quality is bad.

Broadcast SSID: to broadcast the SSID in the Wireless local
area network. When the function is disable, then the wireless
client can not detect the SSID while the client is surveying the
site of the AP.
III. Security
This function is used to protect wireless communication from
eavesdropping. A secondary function of encryption is to prevent
unauthorized access to a wireless network, and it can be achieved by
using the Encryption function.
Click the Enable WEP Security to activate the security of the AP.
 Key Length: to access the WEP Key in 64-bit or 128-bit.

Key Format: to access the key in ASCII format or Hex format.

Default Tx Key: to set the default WEP from Key#1 to Key#4.

Key Setting #1 ~ #4: you can type the key that you want to use
from Key#1 to Key #4, and the key that you type will be the
encryption between the station that you connected with, if you
select 64bit in Hex format, you must type 10 values in the
following range (0~F, hexadecimal), or 64bit in ASCII format,
you must type 5 values in the following range (0~9, A~Z and
a~z Alphanumeric). Besides, if you select 128bit in Hex format,
you must type 26 values (0~F, hexadecimal), or 128bit in ASCII
format, you must type 13 values in the following range (0~9,
A~Z and a~z Alphanumeric).