User's Manual

6
Rear Panel
The figure below shows the rear panel of the Access Point
- +
Ethernet Reset
Rear Panel
Ethernet
Ethernet uplink port with auto-sensing for connecting to either
10/100Mbps Fast Ethernet connections, connect this port to
switch/hub.
Reset
There is two function by pressing the “Reset” button, one is software
reboot and the other is factory reset.

Software Reboot: to reboot the Access Point, press the “Reset”
button.
 Factory Reset: to reset the setting back to factory default setting,
press the “Reset” button within 10 seconds, once you press the
button, the LED of the WLAN will shut down and when the
Access Point is ready, the LED will start blinking.
DC Power
Connect the AC Power Adapter to the AP’s power jack.