User's Manual

3
UNPACKING AND SETUP
This chapter provides unpacking and setup information for the Access
Point.
Unpacking
Open the box of the Access Point and carefully unpack it. The box
should contain the following items:
 One Wireless Access Point
 One external power adapter

One USB cable (A type to B type)

One Installation CD (Driver & Utility + User’s guide)
 Two SMA reverse type antenna (2dBi) (for optional external
antenna of 802.11b Wireless Access Point)
If any item is found missing or damaged, please contact your local
reseller for replacement.
Setup
The setup of the Wireless Access Point can be performed using the
following steps:

Locate an optimum location for the Wireless LAN Access Point
(AP). The best place for your AP is usually the center of your
wireless network, with line of sight to all of your mobile stations.

Visually inspect the Ethernet RJ45 port connector and make
sure that it is fully plugged in to the system’s Ethernet
switch/hub port.
 Fix the direction of the antennas. Try to place the AP in a
position that can best cover your wireless network. Normally,