User's Manual

10
u Operational Rate Set: to select the transfer rate from 11, 5.5, 2
and 1Mbps.
u Beacon Period: to select the time of beacon signal from 20-1000
(Typical 100 millisecond).
u DTIM: Set the DTIM period. Determines at which interval the
AP will send its broadcast traffic. Default value is 4 beacons.
u Antenna: to determine which antennas are used, Left, Right or
Diversity.
u Operational mode: Set one of the following operational modes
on the AP: Access Point / Access Point Client / Wireless Bridge
/ Wireless Repeater.
u Community: to assign the community’s password. The default
password is “public”.
u DHCP Client: Enable/Disable automatic IP address assignment
by the DHCP server
u Primary Port: The interface to determine the DHCP server
(Ethernet Port/ Wireless Port) Authorization Algorithm.
u Preferred BSSID: Remote MAC Address for connection, in
Access Point Client or Wireless Bridge Operational modes.
u SSID Broadcasting: to enable / disable the SSID ID of the
device.
u Configuration Port: to select where the device can be configure,
USB or Ethernet.
u Press “GET” button to display the current setting of the AP.
u Press “SET” button to set the new setting of the AP.
3. Press “RESET AP” to reset the device.
4. Press “Restore Default” to set the default setting back on the
device.