User's Manual

9
2. You may double click the value parameter on the right side as
shown in the figure for advanced settings; some Identifier’s value
may not be modified and some value will be in a range that to
shown in the dialog box.
u MAC Address: showing the MAC ID of the device.
u Regulatory Domain: showing the domain code of the device.
u Eth_IP Address: to set the IP address used by the AP.
u Eth_Submask: to set the subnet address.
u Wirel_SSID: to set the SSID of the Access Point.
u Auto Rate Fallback: to enable or disable the transfer rate auto
fallback.
u Wirel_Channel: to set the channel of the Access Point.
u Wirel_Fragmentation Threshold: the size at which packets will
be fragmented. Choose a setting within a range of 256 to 2346
bytes.
u Wirel_RTS Threshold: Choose a setting within a range of 0 to
2432 bytes. It is recommended limiting a long packet to prevent
each station waiting too long to transmit a data.
u WEP type: to set WEP to be 64 bit, 128 bit or no encryption.
u WEP key: to select which WEP key to be used.
u Key 1 ~ 4: to input the WEP key parameter from key 1 to key 4
u Preamble: to limit the packet size of the data to transmit. It is
recommended to choose the short preamble when the link
quality is bad.
u Authentication type: to choose which authentication algorithm
will be used, open system, shared key or both type.
u Access Point name: to appoint a name for the device.