User's Manual

CONFIGURING THE WIRELESS LAN ACCESS POINT

There are two ways to configure the Wireless Access Point,

configuring through AP utility and SNMP Manager.

Installing the AP Utility and SNMP Manager

The AP Utility and SNMP Manager will help you to configure the

Wireless LAN Access Point through the USB port or Ethernet port.

Note: Please configure through AP Utility before you start using the device.

When the AP is connected to the USB port, the operating system will search

the driver when detecting the device. Put the driver CD into your CD-ROM,

the installation will start automatically. Afterwards, configure through the

AP Utility to get the AP started.

1. Power on your computer and allow Window 98/Me/2000/XP to

load fully. Be sure that there is no AP connected to the computer

at this stage.

2. Insert the driver CD into the CD-ROM and it will execute the

installation program automatically or refer to the “D:\Setup.exe ”

in the dialog box (D:\ will depends on where the CD-ROM drive

is located). Follow the instruction of the instruction step by step.

3. At last, a message will notify you to restart your computer. Select

“Yes” to restart your computer.