User Manual

Professional Access Point
Administrator Guide
Class Structure, Commands, and Examples - 199
Set the Static IP Address
1. Check to see what the current static IP address is. (In this example, the current static IP address is the
factory default.)
USR5453-AP# get interface br0 static-ip
10.10.12.221
2. Re-set to a new static IP address:
USR5453-AP# set interface br0 static-ip 10.10.12.81
Set the Static Subnet Mask Address
1. Check to see the current Subnet Mask. (In this example, the current subnet mask is the factory
default.)
USR5453-AP# get interface br0 static-mask
255.255.255.0
2. Re-set to a new static Subnet Mask:
USR5453-AP# set interface br0 static-mask 255.255.255.128
Set the IP Address for the Default Gateway
This example sets the Default Gateway to 10.10.12.126:
USR5453-AP# set ip-route with gateway 10.10.12.126 in-use yes
Set DNS Nameservers to Use Static IP Addresses (Dynamic to Manual Mode)
This example shows how to reconfigure DNS Nameservers from Dynamic mode (where name server IP
addresses are assigned through DHCP) to Manual mode, and specify static IP addresses for them.
1. Check to see which mode the DNS Name Service is running in. (In this example, DNS naming is
running in DHCP mode initially because the following command returns
up for the mode.)
USR5453-AP# get host dns-via-dhcp
up
2. Turn off Dynamic DNS Nameservers and re-check the settings:
USR5453-AP# set host dns-via-dhcp down
USR5453-AP# get host dns-via-dhcp
down
3. Get the current IP addresses for the DNS Nameservers:
USR5453-AP# get host static-dns-1
10.10.3.9
USR5453-AP# get host static-dns-2
10.10.3.11