User's Manual

Section 3 - Conguration

Enter a name for the rule. You may select a pre-dened

application from the drop-down menu and click <<.

This is the port used to trigger the application. It can be either

a single port or a range of ports.

Select the protocol of the trigger port (TCP, UDP, or Both).

This is the port number on the Internet side that will be used

to access the application. You may dene a single port or a

range of ports. You can use a comma to add multiple ports

or port ranges.

Select the protocol of the rewall port (TCP, UDP, or Both).

The schedule of time when the Application Rule will be

enabled. The schedule may be set to Always, which will allow

the particular service to always be enabled. You can create

your own times in the Tools > Schedules section.

Name:

Trigger:

Trac Type:

Firewall:

Trac Type:

Schedule:

Application Rules

Some applications require multiple connections, such as Internet gaming, video conferencing, Internet telephony and others. These applications have

diculties working through NAT (Network Address Translation). Special Applications makes some of these applications work with the L7-N-R2000.

If you need to run applications that require multiple connections, specify the port normally associated with an application in the “Trigger Port”

eld, select the protocol type as TCP or UDP, then enter the rewall (public) ports associated with the trigger port to open them for inbound trac.

The L7-N-R2000 provides some predened applications in the table on the bottom of the web page. Select the application you want to use and

enable it.

L7-N-R2000 User Manual