User's Manual Part 2

64
Connection Request
User Name: The username the remote ACS should use when connecting to this
device.
Password: The password the remote ACS should use when connecting to this
device.
Path: The path of the device ConnectionRequestURL. The device
ConnectionRequestURL should be configured based on the Device_IP, Path and
Port as follows: http://Device_IP:Port/Path.
Port: The port of the device ConnectionRequestURL.
Logout
This page is used to logout from ADSL gateway.
Click the “Logout” button to logout from the WLAN ADSL Router.
Diagnostic
Ping
Once you have your WLAN ADSL Router configured, it is a good idea to make
sure you can ping the network. A ping command sends a message to the host you
specify. If the host receives the message, it sends messages in reply. To use it, you
must know the IP address of the host you are trying to communicate with and enter
the IP address in the Host Address field. Click “Go” button to start the ping
command, the ping result will then be shown in this page.