User's Manual Part 2

Trap IP Address: Destination IP address of the SNMP trap.

Community name:

Read-only: Name of the read-only community. This read-only community

allows read operation to all objects in the MIB.

Write-only: Name of the write-only community. This write-only community

allows write operation to the objects defines as read-writable in the MIB.

Port Mapping

The WLAN ADSL Router provides multiple interface groups. Up to five interface

groups are supported including one default group. The LAN and WAN interfaces

could be included. Traffic coming from one interface of a group can only be flowed

to the interfaces in the same interface group. Thus, the WLAN ADSL Router can

isolate traffic from group to group for some application. By default, all the

interfaces (LAN and WAN) belong to the default group, and the other four groups

are all empty. It is possible to assign any interface to any group but only one group.

Port Mapping: Select to enable or disable the interface group feature. If disabled,

all interfaces belong to the default group.

Interface Group

To manipulate a mapping group:

1. Select a group from the table.

2. Select interfaces from the available/grouped interface list and add it to the

grouped/available interface list using the arrow buttons to manipulate the

required mapping of the ports.

3. Click “Apply Changes” button to save the changes.