Manual

5
Version 0012017

Step6:Select correct bolt length based on the thickness of your roof
Mounting Bolt Usage
Roof Thickness M6 x 45mm (Qty) M6 x 65mm (Qty)
25mm – 50mm 8 
50mm – 70mm  8
Step7:Join the Intelligent LED wiring from the hatch to the RV’s 12VDC power
source and insulate the connections.
Step8:Hold bracket loosely in place and tighten by hand two opposing bolts.
With power drill add remaining bolts and then tighten all 8. Use the lowest
torque setting being careful not to over tighten. A 5mm Gap will be present
between edge of facia and roof.
Note: bolt torque may need to be adjusted to achieve best results.
Ensure blind runs smoothly.

Step9:Fit the Interior Trim piece once complete
Clean away the excess silicone and allow to cure.
WARNING:Donotoverapplysiliconeasthismayaffecttheaerodynamics
andcausewatertoflowoverthehatch!
WARNING:INSTALLATIONINSTRUCTIONSMUSTBEFOLLOWEDOR
WARRANTYMAYBEVOID.