Camec 4 Season Evolution 660 x 660 Part No. 044479 Installation Guidelines Ver.
Components Supplied in Carton Exterior Assembly* 4 Bolt Caps* 8 M6x45 Bolts* Interior Bracket* User Manual* or 8 M6x65 Bolts* NOTE:- ITEMS NOTED* MUST BE USED OR WARRANTY MAY BE VOID Tools required Power drill or equivalent with 5mm Hex or Allen Key Neutral Cure Silicone Sealant (Non Acetic) Cleaning / Degreasing Fluid The following is a list of all spare parts: Description 4 SEASONS EVOLUTION HATCH FLYSCREEN 4 SEASONS EVOLUTION HATCH OPENING FLAP 4 SEASONS EVOLUTION HATCH WINDER
INSTALLATION Step 1: When framing the RV roof make provision for hatch by providing suitably placed supports to suit a 660mm x 660mm square opening +/ 2mm Step 2: Test fit hatch into cut out area and adjust to suit.
Step 4: Clean roof surface approximately 50mm around the edge of the already cut 660mm square hole and around flange periphery using Isopropanol / Wax and Grease remover / Methylated Spirits or similar. Step 5: Apply a continuous bead of Non Acetic silicone a minimum of 6mm wide to the centre of the flange all the way around the hatch. Do not over apply. Step 6: Air Deflector MUST face forwards.
Step 7: Select correct bolt length based on the thickness of your roof Roof Thickness 25mm – 50mm 50mm – 70mm Mounting Bolt Usage M6 x 45mm (Qty) 8 M6 x 65mm (Qty) 8 Step 8: Hold bracket loosely in place and tighten by hand two opposing bolts. With power drill add remaining bolts and then tighten all 8. Use the lowest torque setting being careful not to over tighten. A 5mm Gap will be present between edge of facia and roof. Note: bolt torque may need to be adjusted to achieve best results.
Camec 4 Seasons Evolution 660 x 660 Operating Instructions: To open ventilation ports on the hatch gently twist one of the four knobs clockwise until corresponding flap opens (Anticlockwise to close). If cooking with a gas appliance it is recommended that hatch flaps be left in the open position. Care should be taken to ensure flaps are closed before departing and driving away. Removal of the Flyscreens Periodic removal and cleaning of flyscreens is mandatory.
