Compact 4kg Front Load Washing Machine Instructions for use
Introduction Please read these instructions for use carefully and all other information enclosed with the washing machine. Keep all documentation in a safe place for future reference or for any future owners. This appliance is intended to be used in RV’s and similar applications such as: - Caravans - Motor Homes - Campers If the appliance is used in a manner inconsistent with the above, it may reduce the life of the appliance and may void the manufacturer’s warranty.
Contents Page Introduction 2 General delivery notes 4 Safety notes 4 Quick start guide 5 Description of controls 6 Wash program guide 12 Program selector 14 Detergent drawer 16 Detergents, washing aids and amounts to use 17 Economical washing tips 19 Washing procedure 20 Cleaning and routine maintenance 22 Troubleshooting 24 Specifications 25 Setup & Installation 26 Warranty Statement 28 BEFORE SWITCHING ON THE APPLIANCE MAKE SURE IT IS CORRECTLY INSTALLED AND THAT THE FIXI
General delivery notes Please check that the following items are delivered with the appliance: - Instruction manual - Inlet hose Check that no damage has occurred during transit, and if so, call your nearest Authorised Camec Dealer. Safety notes. Note: For cleaning or maintenance of the washing machine. A) B) C) D) E) Turn off the power point and pull out the plug. Turn off the tap. Ensure that the mains supply is earthed, and if it is not, seek assistance from a qualified person.
M) Note! If the appliance is installed on a carpeted floor ensure that the ventilation holes on the base of the appliance are not obstructed. N) If the appliance is not running properly or breaks down, switch it off, turn off the tap and do not tamper with the appliance. Consult only an authorised Camec Dealer for possible repair. Failure to comply with the above can compromise the safety of the appliance. Quick start guide Washing - Open the door by using the handle “A” (Fig.
Door handle Press the finger-bar inside the door handle to open the door. Program Start light A B This lights up when the START button has been pressed. “START/PAUSE” function C Press to start the selected cycle . NOTE: When the "Start/Pause" button has been pressed, the appliance can take few seconds before it starts operating. Changing the settings after the program has started (PAUSE) Press and hold the “START/PAUSE” button for about 2 seconds.
Note: Cycle option buttons should be selected before pressing the "Start/Pause" button. D AQUAPLUS function Pressing this button activates a special new wash cycle in the Cotton and Mixed Fabrics programs, thanks to a new Sensor System. This option treats the fibers of garments with care and therefore is a useful feature for people with delicate skin.
F “DELAY START” button This button allows you to to delay the start of the cycle for up to 24 hours. To delay the start use the following procedure: Set the required program.
H “DIGITAL” Display 4 3 1 2 The display’s indicator system allows you to be constantly informed of the status of the washing machine: 1) SPIN SPEED Once the program has been selected, the maximum spin speed allowed for that program appears on the display. Pressing the spin button will reduce the speed by 100 rpm each time the button is pressed. The minimum speed allowed is 400 rpm, or it is possible to omit the spin cycle by pressing the spin button repeatedly.
PROGRAM selector with “OFF” position 11
WASH PROGRAMME GUIDE PROGRAMME SELECTOR ON: PROGRAM FOR: WEIGHT MAX kg TEMP.
Please read these notes ** STANDARD COTTON PROGRAMMES ACCORDING TO (EU) No 1015/2010 and No 1061/2010 COTTON PROGRAMME with a temperature of 60°C COTTON PROGRAMME with a temperature of 40°C These programmes are suitable to clean normally soiled cotton laundry and they are the most efficient programmes in terms of combined energy and water consumption for washing cotton laundry.
Program selector For the various types of fabrics and various degrees of dirt the washing machine has different program bands according to: wash cycle, temperature and length of cycle (see table of washing cycle programs on P12). COTTONS The cottons programs have been designed for a quality wash and the rinses, with specific spin intervals, ensure perfect rinsing. The final spin gives the most efficient removal of water.
FAST SPIN & DRAIN The spin program completes the spin at the maximum spin speed. This can be reduced by using the Spin Speed option button or excluded if you want to drain only. DEDICATED “RINSE” PROGRAM This program carries out three rinses with an intermediate spin (which can be excluded by using the correct button). It can be used for rinsing any type of fabric, eg. use after hand-washing.
P Detergent drawer The detergent drawer is split into 2 compartments: -The compartment labelled "I" is for main wash detergent. -The compartment labelled " " is for special additives ie. fabric softeners, fragrances, starch, brighteners etc. IMPORTANT: ONLY USE LIQUID PRODUCTS IN THE SECOND COMPARTMENT.
Detergents, washing aids and amounts to use Choice of detergent General purpose detergents - Powder detergents. For a thorough wash, with bleaching agent, particularly suitable for use in hot wash programmes (60°C and over), for heavily soiled and stained laundry. Liquid detergents. Particularly suitable for grease stains, such as greasy skin marks, cosmetics and oil. These detergents may not be as effective for washing stained laundry, as they may not contain bleach.
Dosages Only use detergents which are suitable for use in a Front Load washing machine. You will obtain the best results from your wash with the minimum use of chemical products and the best care for your laundry if you take into consideration the degree of soiling as well as the type of detergent to choose. The amount of detergent to use depends on: � the degree of soiling: it is possible to reduce the amount of detergent used depending on how dirty the load is.
Economical Washing Tips Tips on using your appliance in the most environmentally-friendly and economical way. Do a full load in your washing machine To prevent any possible waste of energy, water or detergent we recommend that you put a full load in your washing machine, not exceeding the recommended maximum load size. Up to 50% energy saving can be made with one full load compared to two half load washes When is prewashing really needed? Only with particularly dirty loads.
Washing Procedure Sorting the laundry - It is recommended you wash only items which are machine washable with water and detergent and not dry-clean items. - If you need to wash rugs, bedspreads or other heavy items, it is best not to spin them.
Washing Procedure cont’d Preparing the laundry A) Select the laundry. Loading the laundry B) Open the door. C) Put the laundry in the washing machine. Close the door again, ensuring that no items of laundry are obstructing the lock. Putting detergent in machine D) Open the drawer, choose the detergent and put it in the correct amount, according to the manufacturer’s instructions and the advice on page 17. Add any other laundry aids (see page 17). Close the drawer again.
After cleaning, replace the filter, replace by turning the notch at the end of the filter clockwise. Then follow the procedures above in reverse order.
Cleaning the door glass Regularly clean the door glass with a damp cloth. A build up of soiling and residues from the water may result in water leaking from the door. Do not use abrasive cleaners as they can scratch the surface. Storing the appliance or long periods when appliance is not in use If the appliance is being stored or is out of use for long periods, all remaining water must be completely removed from the hoses.
TROUBLESHOOTING Possible causes of problems and their remedies… water Drain hose bent – If the fault should persist, contact a Camec Authorised repairer.
Important 1 The use of environmentally friendly detergents without phosphates may produce the following results: The used rinse water may be cloudier due to the presence of zeolites in suspension. This does not compromise the efficiency of the rinses. The presence of white powder (zeolites) on the washing at the end of the washing cycle. This does not remain embedded in the fabric and does not alter the colour.
SETUP & INSTALLATION Remove the polystyrene base and place the machine near its permanent position. Carefully cut through the hose retaining clip at the rear of the appliance (diagram 1). Unscrew the two top screws A and remove the top cover, sliding it off horizontally (diagram 2). Remove the cardboard protection. Unscrew the two bolts B on the crosspiece (with 19mm spanner) & remove the polystyrene spacer under it (diagram 3). Please do not re-fit the bolts.
Rotate the foot to raise or lower the machine until it stands evenly on the RV floor. Lock the foot in position by turning the nut anti-clockwise until it touches the machine,.
Note: it is advisable to turn off the tap after each wash to isolate the washing machine from the water supply. For the washing machine to function properly the terminal end of the drain hose (mouth) must be at a minimum of 50 cm and a maximum of 85 cm from the ground. ELECTRICAL CONNECTIONS This washing machine is specified to operate at a voltage of 220-240 V, 50 Hz singlephase. After installation, the appliance must be positioned so that the plug is accessible.
V1.1 © 2014 Camec Pty. Ltd. As Camec continually strives to improve our products, specifications and design are subject to change without notice. Please dispose of thoughtfully, recognizing local regulations.
