User guide

15
All the data and information contained herein is considered subject to change at any time and at our discretion
ENGLISH


567%
,
.

 

0 
# #
%" %"
#/.42/,"/!2$
:"8
#(
,4 ,4 #4   
&! &# & " "
#(
!&02/'
1) Insert the terminal (-, +)
connected to the battery
to the free coupling of the
motherboard.
Note: the board must be battery-
powered for saving procedures.
Check the LED signalling 230V
power is off.
8.2 Battery connection and memorization of the code on the control board
12V - 1.2 Ah
emergency batteries
Battery bracket
Led 230V power-supply signal
Electric lock
Transformer
Terminal -, +
#(
#(
!&02/'
#(
#(
!&02/'
2) Keep the key (ref. point 19, page 8) on the basic board
depressed. The signalling LED (ref, point 18, page 8)
fl ashes (intermittent LED).
3) Press a key (the same one memorized for ope-
ning the gate) on the transmitter to send the code.
The LED will remain lighted to signal successful
memorization.
N.B.: if the code needs to be changed, repeat the
sequence described above.
AF2
Save button of the radio-code
of the “pratico system”
Flashing LED
Lit LED