Installation manual


,4 ,4 #4 63 6&
567%
,
.
  43    0   # #
%" %"
&# &! &
12V - 1.2 Ah
emergency batteries
Battery bracket
Led 230V power-supply
signal
Electric lock
Transformer
Condenser
Terminal -, +
15
All the data and information contained herein is considered subject to change at any time and at our discretion
ENGLISH
2) Keep the key (ref. point 18, page 8) on the basic
board depressed. The signalling LED (ref, point 17,
page 8) fl ashes (intermittent LED).
3) Press a key (the same one memorized for
opening the gate) on the transmitter to send
the code. The LED will remain lighted to signal
successful memorization.
N.B.: if the code needs to be changed, repeat the
sequence described above.
1) Insert the terminal (-, +)
connected to the battery
to the free coupling of the
motherboard.
Note: the board must be
battery-powered for saving
procedures. Check the LED
signalling 230V power is off.
8.2 Battery connection and memorization of the code on the control board
%,%#42)#
",/#+
!
!&
!&
#(
%,%#42)#
",/#+
!
!&
!&
#(
AF2
Save button of
the radio-code
of the (pratico
system)
Flashing LED
Lit LED