User guide

X 2
X 2
X 2
X 2
X 15
X 16
X 13
X 14
Pag.
16
16 - Manual code:
319U75
319U75 ver.
2.0
2.0 01/2009 © CAME cancelli automatici s.p.a. - The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
< endstop >
N.C
endstop
< N.C >
Endstop: configure the endpoints are normally closed or open contacts.
N.B.: this function appears only if selected from the “Config.” function in the FUNCTIONS menu.
< cmd 2-7 >
Op.-Stop-Cl.
cmd 2-7
<Op.-Stop-Cl.>
Command 2-7: setting the 2-7 contact to step-by- step mode (open-close) or sequential (open-stop-close-stop).
endstop
< N.A >
cmd 2-7
<Open-Close>
< cmd 2-3P >
Pedestrian
cmd 2-3P
< Pedestrian >
cmd 2-3P
< Partial >
< lamp E3 >
Cycle
lamp E3
< Cycle >
lamp E3
< Courtesy >
Command 2-3P: setting the 2-3P contact to pedestrian opening (second gate leaf opens fully) or partial (second gate leaf opens
partially depending on the time set on “Partial opening” from the Adjust Times menu).
E3 lamp: configuring the lamp connected to E-E3:
- cycle: outdoor lamp, which can be positioned at leisure, for better illumination in the parking/driveway area.
It stays on from the moment the gate leaf begins to open, until it is fully closed (including automatic closing time).
In case the automatic closing function is not inserted, it stays on only during gate movement.
- courtesy: outdoor lamp, which can be positioned at leisure, for better illumination in the parking/driveway area.
It stays on for a set time of 5 minutes.
<
LANGUAGE
>
English
sh
FUNCTIONS
TIMING ADJ.
TIMING AD
USERS
INFO
TEST MOT.
TEST MOT
<
LANGUAGE
>
English
sh
FUNCTIONS
TIMING ADJ.
TIMING AD
USERS
INFO
TEST MOT.
TEST MOT
< LANGUAGE >
English
sh
FUNCTIONS
TIMING ADJ.
TIMING AD
USERS
INFO
TEST MOT.
TEST MOT
<
LANGUAGE
>
English
sh
FUNCTIONS
TIMING ADJ.
TIMING AD
USERS
INFO
TEST MOT.
TEST MOT