Manual

0
0
0
0
0
0
0
0
Pag.
30
30 - Manual code:
319U98
319U98 ver.
0.1
0.1 01/2009 © CAME cancelli automatici s.p.a. - The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
7.17 Gate run calibration
1) From the Encoder
menu, select “Set
Encoder”. Press ENTER
to confirm.
2) Select “confirm
(yes) and press ENTER
to confirm.
3) the gate leaf of the
first motor will perform
a closing run until fully
closed.....
4) …then, the
gate leaf of the
second motor will
perform the same
manoeuvre…
5) …then, the gate leaf
of the second motor, will
perform and opening run
until fully open…
6) ...after which,
the gate leaf of
the first motor will
perform the same
manoeuvre…
7) When the procedure is
finished, the display will show
“Set Encoder ok” for a few
seconds.
N.B. before calibrating the gate run, check that the manoeuvring area is free of any obstacles and check the proper direction of rotation of the
gearmotors. (para. 7.11)
7.18 Error messages
-“encoder ERROR”: check proper connections or functionality of the device and possibly even the motor’s torque”
-“safety d. test ERROR”: malfunctioning of safety devices, check proper functioning of connections and functionalities;
-“end stop ERROR”: check proper connections on end point connections or functionality of devices;
-“cycle time ERROR”: check the working time settings, the set time may be insufficient to complete the duty cycle.
- Safety STOP, C1, C3, C4”: check proper functioning of connections and functionalities of devices.