Manual

X 7
X 2
X 8
X 2
X 9
X 2
X10
X 2
Pag.
21
21 -
Manual code
:
319U98
319U98
ver.
0.1
0.1 01/2009 © CAME cancelli automatici s.p.a. -
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
FUNCTIONS
F
TIMING ADJ.
T
D
USERS
INFO
ENCODER
Imp. Run
n
FUNCTIONS
F
TIMING ADJ.
T
D
USERS
INFO
ENCODER
Imp. Run
n
FUNCTIONS
F
TIMING ADJ.
T
D
USERS
INFO
ENCODER
Imp. Run
n
FUNCTIONS
F
TIMING ADJ.
T
D
USERS
INFO
ENCODER
Imp. Run
n
< M2 Slow.CH % >
10
M2 Slow.CH %
< 10 >
M2 Slow.CH %
< 11 >
M2 closing deceleration %: this adjusts the (M2) second motor’s deceleration starting point before the closing endpoint.
The deceleration starting point is calculated as a percentage (from 1% to 40% of a full gate run). See illustration on page 28.
N.B.: this function appears only if it is activated in the “decel. Enc” function in the ENCODER menu.
< M1 Appr.CH % >
5
M1 Appr.CH %
< 5 >
M1 Appr.CH %
< 6 >
M1 closing acceleration %: this adjusts the (M1) first motor’s percentage rate of approach to the final closing and opening points
before reaching the opening and closing endpoints. The percentage rate of approach to (goes from 1% to 15% of the full gate run). See
illustration on page 28.
< Set Encoder >
Set Encoder
<confirm?(no)>
Set Encoder
<confirm?(yes)>
See detailed
description on
page 28
M2 closing acceleration %: this adjusts the (M2) second motor’s percentage rate of approach to the final closing and opening points
before reaching the opening and closing endpoints. The percentage rate of approach to (goes from 1% to 15% of the full gate run). See
illustration on page 28.
< M2 Appr.CH % >
5
M2 Appr.CH %
< 5 >
M2 Appr.CH %
< 6 >
Gate run calibration: calibrates the gate’s opening and closing runs and decelerations.