Manual

X 2
X 2
X 2
X 2
X 15
X 16
X 13
X 14
Pag.
16
16 - Manual code:
319U98
319U98 ver.
0.1
0.1 01/2009 © CAME cancelli automatici s.p.a. - The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
< endstop >
N.C
endstop
< N.C >
Endstop: configure the endpoints are normally closed or open contacts.
N.B.: this function appears only if selected from the “Config.” function in the FUNCTIONS menu.
< cmd 2-7 >
Op.-Stop-Cl.
cmd 2-7
<Op.-Stop-Cl.>
Command 2-7: setting the 2-7 contact to step-by- step mode (open-close) or sequential (open-stop-close-stop).
endstop
< N.A >
cmd 2-7
<Open-Close>
< cmd 2-3P >
Pedestrian
cmd 2-3P
< Pedestrian >
cmd 2-3P
< Partial >
< lamp E >
Cycle
lamp E
< Cycle >
lamp E
< Preflashing >
Command 2-3P: setting the 2-3P contact to pedestrian opening (second gate leaf opens fully) or partial (second gate leaf opens
partially depending on the time set on “Partial opening” from the Adjust Times menu).
Lamp E: setting up the fl ashing light or cycle lamp connected on 10-E:
- cycle: outdoor lamp, which can be positioned at leisure, for better illumination in the parking/driveway area.
It stays on from the moment the gate leaf begins to open, until it is fully closed (including automatic closing time).
In case the automatic closing function is not inserted, it stays on only during gate movement.
- fl ashing light: signals the gate opening or closing movement.
< LANGUAGE >
ANGUAG
English
E
FUNCTIONS
TIMING ADJ.
I
J
USERS
I
NFO
Imp. Run
n
< LANGUAGE >
ANGUAG
English
E
FUNCTIONS
TIMING ADJ.
I
J
USERS
Imp. Run
n
< LANGUAGE >
ANGUAG
English
E
FUNCTIONS
TIMING ADJ.
I
J
USERS
INFO
Imp. Run
n
< LANGUAGE >
ANGUAG
English
E
FUNCTIONS
TIMING ADJ.
I
J
USERS
Imp. Run
n