User's Manual

- 34 -
Way to enter menu : * (Hold down for more than 2 seconds), (Admin password) #
Menu
Parameter or operation step
Function
Default value
2#
Double-doors mode
3#
Interlock mode
9#
Demo mode
09
0000#
Restore default settings, admin password and user
information unchanged.
32
0#
Set lock to Delay mode
0
1#
Set lock to Switch mode
2#
Set the lock to Normal-open mode
34
0#
Set Open-time to 50mS
2
(1-999)#
Set Open-time from 1 to 999S
51
1,1,…,#
Decrease the brightness of the normally bright red indicator
18
2,2,…,#
Increase the brightness of the normally bright red indicator
52
0#
Key backlit is always off
1
1#
Key backlit is always on
(2-99)#
After delay 2-99 seconds, Key backlit turn to micro light
53
1,1,…,#
Decrease the brightness of the backlit
14
2,2,…,#
Increase the brightness of the backlit
55
1,1,…,#
Decrease the keypad tone
10
2,2,…,#
Increase the keypad tone
6 Precautions in use
 Lead line cannot be connected wrong, especially the power line, otherwise the machine may be burned or not work
properly.
 Because the machine internal relay is used for signal output, cannot directly drive large power load, in order to ensure
the long-term stable operation of the machine, the electric lock be not connected directly with NO, NC, COM of the
machine, but driven by an access control special power supply.
 When you enter the management mode or change the user PIN, you must press and hold the * key for more than two
seconds to be valid.
 Is for the sake of safety, the default admin initial password 888888 only support the menu 00, which forced users to
change the 6-digit admin password, or cannot access other settings.
 The factory default mode is the single-door mode. If you need other mode functions, you must enter the appropriate
mode to operate properly. In different modes, the management menu is also different.