Manual

OFF
SLOW
FAST
CLIP LIMITER
26 dB
1,4 V
32 dB
26 dB
1,4 V
32 dB
DC BA
:LEDOM
:PMI/HCREPRWPTUPTUO
YNAMREGNIEDAM
:.ON.RES
D ABC
Do not remove this cover or
connect any loudspeaker
cables while the amplifier is
running!
See the manual for detailed
cabling instructions
Warning! Risk of
electrical shock
.
D C B A
D C B A
:LEDOM
:PMI/HCREPRWPTUPTUO
YNAMREGNIEDAM
:.ON.RES
www.camcoaudio.com
Specifications:
Q-Power 6
Q-Power 10
Power per channel
All channels driven
@ 1kHz, THD < 1%
16 Ω 470 W 620 W
8 Ω 800 W 1100 W
4 Ω 1000 W 1800 W
4 Ω Max RMS 1500 W 2500 W
70 V line operation 950 W 1600 W
100 V line operation N/A 625 W
Power per channel
Single channel driven
@ 1kHz, THD < 1%
16 Ω 480 W 620 W
8 Ω 960 W 1350 W
4 Ω 1500 W 2400 W
4 Ω Max RMS 1600 W 2600 W
No. of channels
4 4
Max. Output Voltage
125V
p
/ 250V
pp
145V
p
/ 290V
pp
Output Circuitry
Class H Class D
Signal To Noise-Ratio
20 Hz - 20 kHz, 8 Ω load
> 115 dB (A-weighted)
> 112 dB (unweighted)
> 115 dB (A-weighted)
> 112 dB (unweighted)
THD+N (typical)
20 Hz - 20 kHz, 8 Ω load,
6 dB below rated power
< 0,01 % < 0,01 %
SMPTE 4:1 (typical)
60 Hz + 7kHz, 8 Ω load
8 dB below rated power
< 0,01 % < 0,02 %
Damping Factor
8 Ω load, 1 kHz and below
> 350 > 600
Net Weight
10,6 kg / 23,4 lbs 11,5 kg / 25,4 lbs
Shipping Weight
12,6 kg / 27,8 lbs 13,5 kg / 29,8 lbs
Frequency Response
8 Ω load, 1 dB below rated power
20 Hz - 20 kHz ± 0,15 dB
Input Impedance
15 kΩ balanced
Input Gain
selectable: 26 dB, 32 dB or 1,4 V input sensitivity
Protection Circuits
inrush-current limitation, protection circuits against power on/off transients, temperature monitoring of
transformers and heat-sinks, output DC protection, power transistor control, temperature dependent SOA
protection, intelligent mains fuse protection
Limiter
two switchable peak-limiter for channel A+B and C+D respectively
Fan
2 temperature dependent speed-controlled axial fans
Indicators
LED’s for ON, SIGNAL/PROTECT, CLIP, Output Current
Input Connectors
3-pin XLR, male and female per channel, pin 2 = in phase / Phoenix Connectors, pin 1 = in phase, pin 2 = GND
Output Connectors
Two 4-pole SPEAKON connectors / Barrier Strip with protection cover
Operation Voltage
Dual Voltage SMPS with automatic voltage selection for 120 V / 230 V operation
Dimensions (WxHxD)
483 x 88,9 x 419 mm / 19 x 3,5 x 16,5 inches (19”, 2U)
Shipping Dim. (WxHxD)
600 x 105 x 527 mm / 23,3 x 4,1 x 20,7 inches
Accessories included
Gain pot security cover
Specifications subject to technical alterations without prior notice.
Input Channel D
Gain Setting
(26 dB, 32 dB, 1,4 V)
Channel A & B output
Input Channel C
Input Channel B
Input Channel A
Channel C & D output
Input Channel D & C
Clip Limiter Channel D & C
(Off, On)
Input Channel B & A
Clip Limiter Channel B & A
(Off, On)
Channel D, C, B & A output (barrier strip)