Installation Manual

1. Using enclosed elastic cord, tie one end through grommet and secure permanently.

2. Open both front doors, lay cover across windshield using center seam to align with the

center of the windshield.

3. Place cover under windshield wipers.

4. IMPORTANT: If cover overlaps at top of windshield, leaving enough loose material to

flap, fold overlapping material down and under cover to secure excess material when

cover is in place.

5. After aligning cover, put unsecured end of elastic cord through grommet and secure

tightly. Cover should be smooth and tight (see photo).

6. Close doors on cover making sure cover is tight and is not allowed to move or flap

loose during transit.

RECOMMENDATIONS: CHECK COVER FREQUENTLY TO MAKE SURE IT IS NOT

ALLOWED TO MOVE OR FLAP LOOSE, AS THIS MAY CHAFE PAINT SURFACE.

MANUFACTURER AND DEALER WILL NOT BE RESPONSIBLE FOR DAMAGE CAUSED

BY MISUSE OR NOT FOLLOWING INSTRUCTIONS.

#507

Windshield Protector Cover

Installation Instructions

SINCE 1966

GOLD COAST

BY CAMCO

Camco Manufacturing, Inc.

121 Landmark Drive / Greensboro, NC 27409

1-800-334-2004 / www.camco.net