Instructions / Assembly

ASSEMBLY INSTRUCTIONS

5-3. Load head assembly by inserting hose into post.

Insert head assembly into post.

Control knob should be above decal on post.

Attach head assembly to post, and loosely install four

stainless steel bolts. Tighten bolts securely.

5-3

Hardware Used

6. WARNING:Remove protective cover before

assembling.

Note: If necessary for proper alignment of reflector

sections, loosen each bolt prior to further assembly

and retighten after sections are aligned.

7. Slide two reflector panels together.

Insert one

screw M6 X 10 (II). Slide one washer Φ 6

(HH) over threaded end of

screw M6 X 10 (II) and

screw on cap nut (JJ) loosely.

x 9

Washer Φ 6

Screw M6 X 10

Cap nuts