Instructions / Assembly

7
ASSEMBLY INSTRUCTIONS
Hardware Used
4
5
4. Secure post (J) to cylinder housing (H) using the
reinforced ring (NN), M6 x 10 mm bolts (DD) and
Φ6 small flat washers (EE). Fasten and cover
with the deck ring (OO).
5. Slide fastening nut (G) down the post (J) with the
rounded side facing down. Next, slide the tightening
spacer (F) down the post (J) with the smaller side facing
down. Put the table (E) on the post (J) with the metallic
side facing up.
6. Insert the screw coupler (D) on the post (J), inserting
it through the middle of the table (E) on the post (J).
Thread the tightening spacer (F) on the bottom of the
table (E) counterclockwise onto the screw coupler (D).
Tighten securely to hold the table (E) to the screw
coupler (D). Thread the fastening nut (G)
counterclockwise. Tighten securely to lock in place.
Loosen the fastening nut (G) to adjust the position of the
table (E) on the post (J).
NN
EE
NN
Φ6 Small Flat Washer
x 4
x 1
Reinforced Ring
OO
x 1
Deck Ring
oo
G
G
F
J
J
H
E
E
J
F
6
D
DD
M6 x 10 mm Bolt
x 4