Instructions / Assembly

10. After making any necessary adjustments to the parts, use the hex bolt driver to tighten

all bolts. Note: each bolt must be tightened a few revolutions at a time. Repeat until all bolts

are tight. Do not over tighten. Over tightening may strip bolts. Cover all bolts with covers.

11. Pour the lava rocks or fire ice into the burner pan completely covering the burner. The

weight of lava rocks is (3.6kg plus and minus 10%); the weight of the fire ice is (8kg plus and

minus 10%). Remove any lava rocks or fire ice on top of the ignition well. See Figure 11.

Figure 11

12. Open the tank valve. Apply a solution of soapy water to the tank-regulator connection and

to the valve-hose connection to check for leaks as shown in Figure 12. If soap bubbles

continue to form, the connection has a leak. If a leak is found, close the tank valve and tighten

all connections.

NOTE: NEVER USE A FLAME TO CHECK FOR LEAKS.

Checking the tank-regulator for leaks

Figure 12