Instructions / Assembly

9
8. Place gas tank onto the LP support as shown in Figure 8.
Figure 8
9. Attach the metal ring (as shown in Figure 9) pre-fitted with the regulator hose which is
connected to the table top, into the hole in the door panel, then use the hex wrench
to turn the 1/4"x5mm nuts with Ø6.5x1.0 mm washers. The propane tank is now affixed as
shown in Figure 9a. Connect the regulator as shown in Figure 10. Turn the black handle
clockwise to tighten. Turn the handle counterclockwise to remove. The hose must point
down. Check that the valve is turned all the way clockwise to the "OFF" position.
Figure 10
Figure 9a
Figure 9b