Manualshelf

Instructions / Assembly

ManualsBrandsCambridge ManualsFire Pit SetsConcord 5-Piece Aluminum Outdoor Conversation Set with Tan Cushions and Cast-Top Fire Pit Table
12345678910
7
INSTALLATION
1. Carefully unpack all items from the box. Place the base in the final position. There must be a
minimum of 24 in / 60.96 cm of clearance from the side of the table top to any combustible
walls.
2. Attach the back panel to the side panels (1 and 2) by using four 1/4"x45 mm bolts and
Ø6.5x1.0 mm washers as shown in Figure 2. Guide the bolts through the holes in back panel,
into the pre-drilled holes in the side panels. Hand tighten only.
Figure 2
3. Attach the middle support to the side panels by using two 1/4"x20 mm bolts and Ø6.5x1.0
mm washers as shown in Figure 3. Guide the bolts through the holes in the middle support, into
the pre-drilled holes in the side panels. Hand tighten only.
Figure 3
4. Attach the bottom connector to the right side panel by using a 1/4"x15 mm bolt and washer
as shown in Figure 4. Guide bolt through hole in bottom connector, into pre-drilled hole in the
side panel. Do not over tighten.
Figure 4