Operation Manual

751R V2azur
7
ENGLISH
7
Video 1/2, Recorder 1/2, BD/DVD, CD and Aux
Please refer to the connection diagrams later in this manual for more
information on these inputs and outputs.
8
Heat tunnel vent grille
Allows cooling of internal circuitry via the 751R V2's proprietary X-TRACT heat
tunnel. DO NOT OBSTRUCT!
9
Service (USB)
For dealer use only – Used for future rmware update.
10
Front IR switch
Turns the unit's built-in IR receiver reception on/off if it is desired to use an
IR repeater system plugged into the rear Main Zone IR Emitter Input instead.
11
Zone 2
Independant stereo audio and analogue video outputs to a second Zone (i.e.
a room or area separate from the main area. The IR Emitter input allows
control of the 751R V2 and its sources remotely from that Zone. See Zone 2
section in this manual for details.
12
Component video inputs
By default the component inputs are unassigned, these inputs can be freely
assigned, see later section on assigning video inputs.
Note: The preferred connection method for video inputs is always Composite
Video, then S-Video, then Component Video, then HDMI in ascending order
of quality (HDMI being the highest quality). HDMI and Component Video
sources often also support Progressive Scan which gives better picture
quality if supported by both your BD/DVD player and TV.
13
Multi-Channel In
Connect to the output terminals of a DVD-A, SACD player or other 5.1/7.1
analogue source.
14
Multi-Channel preamp out
Connect to the 5.1/7.1 channel input terminals of another amplier system,
separate power amps, subwoofer or active loudspeakers. Two subwoofer
outputs are supported with both receiving the same signal.
15
IR emitter out
Use with IR Emitters to control the sources from Zone 2 remotely. See later
section.
16
Trigger out
12V triggers for controlling external ampliers, curtains, motorised screens
or other such equipment. See later section.
17
Main zone IR emitter in
Allows modulated IR commands from multi-room systems or IR repeater
systems to be received by the 751R V2.
18
Control bus
In - Allows un-modulated commands from multi-rooms systems or other
components to be received by the unit. (Main Zone only)
Out - Loop out for control bus commands to another unit.
Note: The Emitter inputs are not looped out of the Control Bus output.
19
Power on/off
Switches the unit on and off.
20
Mains power lead
Once you have completed all connections, plug the AC power lead into an
appropriate mains socket. The AV receiver is now ready for use.
21
Speaker terminals
Connect to loudspeakers with an impedance of 8 ohms. 7.1, 5.1 or less
connections can be made.