User's Manual

BC01-um-001c Page 9 of 26

4 HARDWARE SETUP

Remove the power supplies and the appropriate mains power connectors from the

carry case and push the mains connector onto the power supplies, making sure that

they are fully pressed home. Plug these two power supplies into the mains but DO

NOT connect the DC output connector to the BlueCore Evaluation System units

yet. The power supplies should be connected AFTER the BlueChat application is

installed and configured.

Remove the two serial cables from the carry case and connect one end of each to the

COM ports on two PC’s (Windows

98 / NT). Connect the other ends of the serial

cables to the COM1 port of each of the CASIRA Bluetooth Development kit Units.

Remove the two headsets from the carry case and connect one to each of the CASIRA

Bluetooth Development kit Unit headset sockets.