User's Manual

BC01-um-001c Page 19 of 26

14.1 Installing the CSR_Flashloader program.

System Requirements for Installing the Flash Loader Application

- Pentium processor-based personal computer

- Microsoft Windows

98 or Windows

NT v4.0 (service pack 3.0 or later)

- 16 MB of RAM (24 MB recommended)

- 10 MB of available hard disk space which includes room for the Firmware binary

files.

Installation instructions

1. Insert the CASIRA Bluetooth Development kit CDROM into your CDROM

drive.

2. From your CDROM run the “install.exe” file from the

“software\host\CSR_Flashloader” folder which will created on your hard

drive.

3. From your CSR_Flashloader directory create a shortcut for

CSR_Flashloader.exe and place it on your desktop or taskbar as required

for convenience.

4. Select close from the unzip menu to exit.

14.2 Connecting the SPI lead for Firmware updates.

Before using the CSR_Flashloader program the SPI programming lead must be

connected to the Evaluation module.

Commence as follows:

1 Remove all leads from the Evaluation module.

2 Undo the three lid retaining screws in the base of the module.

3 Connect the SPI programming lead to the connector marked “CN16 SIF”.

4 Connect the other end of the lead to the PC printer port.

5 Connect the DC connector to the “pwr” socket and verify the power LED is

lit.