User's Manual

BC01-um-001c Page 17 of 26
11 DISCONNECTING AN ACL CONNECTION
Pressing the Disconnect button at either system unit will stop the command transfer
and close down the ACL connection
It is necessary to re-establish the roles of master and slave after a disconnect.
However the BlueChat application will remember the Bluetooth device addresses
from previously discovered slaves so it is not necessary to repeat an Inquiry before re-
establishing an ACL connection.
12 INITIATING AND BREAKING AN AUDIO CONNECTION
At startup the default Xfer type is Data.
The audio connection can be established by selecting the Audio button after an ACL
connection has first been esatblished
Audio communication between the two headsets is now enabled.
To disconnect an audio connection press the Disconnect button.
It is necessary to re-establish the roles of master and slave after a disconnect.
However the BlueChat application will remember the Bluetooth device addresses
from previously discovered slaves so it is not necessary to repeat an Inquiry before re-
establishing an ACL connection. After a new connect the audio connection should be
re-established.