User's Manual

BC01-um-001c Page 14 of 26
On completion of the Inquiry, the addresses of any Slaves found will be shown in the
“Bluetooth Device Addresses” list. Next select a Slave from the list as shown below.
It is only necessary that the the address is shown (selected) in the “Connect to:”
window, it is NOT necessary to hit return at this point.
Next click on the Connect button at the master
If only one slave is discovered then its address automatically appears in the “Connect
to:” window and it is then only necessary to click on the “Connect” button.
The ACL link to the Slave is now set up and the following results are shown at the
master