User's Manual

BC01-um-001c Page 13 of 26
8 ESTABLISHING AN ACL CONNECTION
First make sure that the Xfer type is still set at the default power-on value of ‘data’.
Then select the Role of one unit to be the slave by selecting the slave button:
Selecting a slave causes the first unit to enter inquiry scan mode:
Next, selecting the role of the other system unit to be master will now cause an
“Inquiry” to be initiated by the master
The master now collects Bluetooth addresses from Slave modules that can been found
on the radio channels.
The “Host Controller Interface Message” window will give information on the results
of the Inquiry. This procedure should take approximately 10 seconds to complete. It
is usual to see 8 responses after inquiry scan is complete :
The user must ensure that the CASIRA Bluetooth Development kit Units are NOT
both set to the same Role
WARNING –See appendix for a known software
deficiency after initial power up of System Units