ASSEMBLY INSTRUCTIONS WICKER ROCKING CHAIR IT-130979 CUSTOMER SERVICE INFORMATION Please email us at for assembly tips, report damage, or request parts. For faster response, please write down Hera number, code for raising parts, attach the purchase receipt and picture of damaged parts.
GENERAL INFORMATION & TIPS 1. Please read the assembly instructions prior to assembling the Rocker. 2. To avoid damage, assemble the rocker on a non-abrasive surface such as carpet. 3. Make sure all bolts tightly fastened before the rocker is used. 4. This rocker is not for commercial use. Please make sure you have all parts before beginning assembly. Please wait until all steps are completed before tightening bolts. TOOLS REQUIRED 1. 8" Philips screwdriver (Not provided).
Install Head Back Support {B), Back support {Can Seat (I) into matching holes of Right Side Frame {A1). Attach the Left Side Frame {A2} onto Apron (B), Back support {C) and Seat Secure Left Side Frame {AZ} using 1 3/4° Bolts (E) and 2” Bolt {F}, as shown. Invert the rocker and repeat the step 1 procedures fo secure the Right Side Frame {Al}. STEP 3 Upright the rocker. Make sure all pairs are correctly commented and tighten all bolts using screwdriver.
MAINTENANCE Wood 1s a living material that continues to respond to climate condition even after being made info a piece of furniture. After assembly rub the furniture with soft mag to remove any residual dust. Wood isa natural material whose appearance will change when left outdoors. This product has been treated prior to leaving the factory.
year Limited warranty The furniture is warranted to be free from defects in material and workmanship of the original product when purchased from one of our authorized dealers. If a product fails and is under the terms of our limited warranty, the tem will be replaced, usually fora small fee. In the case of discontinued models, an item of similar quality and style will be offered to the customer.
