Installation guide

10 Incognito LM10
It is possible to add up to two LM10 units per main zone. This gives you the option to listen to
either one by selection from the keypad or LR10 remote control (Local1/Local 2). The module
needs to be told whether there are one or two LM10’s present.
Dual LM10s fitted in a single zone
Connect the LM10s as shown in the opposite diagrams.
Local Source 1 – Switch over SW1 (LC1) to the ON position and SW2 (LC2) to the OFF position.
Local Source 2 – Switch over SW1 (LC1) to the OFF position and SW2 (LC2) to the ON position.
Note: If using an LR10 to select the local source, this will ONLY select Local 1 as default.
CAT-5 CONNECTIONS CONTINUED