Spec Sheet

Specifications
CN PTP650 09172014
SPECIFICATION SHEET: PTP 650
RADIO TECHNOLOGY
MODEL PTP 50650
RF BANDS
1
Wide-band operation 4.9 to 6.05 GHz (Allowable frequencies and bands are dictated by individual country regulations. The most com-
mon bands are listed here.)
4.940 – 4.990 GHZ (Public Safety)
5.15 – 5.25 GHZ
5.25 – 5.35 GHZ
5.470 – 5.725 GHZ
5.725 – 5.850 GHZ
5.825 – 6.050 GHZ
CHANNEL SIZES 5, 10, 15, 20, 30, 40, and 45 MHz channels
Channel sizes depend on individual country regulations
SPECTRAL EFFICIENCY 10 bps/Hz maximum
CHANNEL SELECTION By Dynamic Spectrum Optimization or manual intervention;
automatic selection on start-up and continual self-optimization to avoid interference
MAXIMUM TRANSMIT POWER
2
Up to 27 dBm at BPSK; up to 23 dBm at 256 QAM
SYSTEM GAIN
2
Integrated: Up to 164 dB with 20 MHz channel and integrated 23 dBi antenna; varies with modulation mode, channel size and spectrum
Connectorized: Varies with modulation mode and antenna type
RECEIVER SENSITIVITY -98 dBm with 5 MHz channel
MODULATION / ERROR CORRECTION Fast Preemptive Adaptive Modulation featuring 13 modulation / FEC coding levels ranging from BPSK to 256 QAM dual payload MIMO
DUPLEX SCHEME Time Division Duplex (TDD)
Adaptive or fixed transmit/receive duty cycles. Split frequency operation allows separate transmit and receive frequencies where allowed
by regulation.
Optional TDD synchronization using PTP-SYNC Module
ANTENNA Integrated: Flat panel – 23 dBi
Connectorized: Can operate with a selection of separately-purchased single- and dual-polarity antennas through 2 x N-type female
connectors (local regulations should be checked prior to purchase)
RANGE Up to 124 miles (200 km)
SECURITY FIPS-197 compliant 128/256-bit AES Encryption (optional)
HTTPS and SNMPv3
3
Identity-based user accounts
Configurable password rules
User authentication and RADIUS support
Event logging and management; optional logging via syslog
Disaster recovery and vulnerability management
ETHERNET BRIDGING
PROTOCOL IEEE 802.3
USER DATA THROUGHPUT Dynamically variable up to 450 Mbps
Maximum conditions – 2x2, 45 MHz channel
1
, 256 QAM
Flexible spectral eciency / capacity licensing model:
Lite Capacity: Up to 125 Mbps
Mid Capacity: Up to 250 Mbps
Full Capacity: Up to 450 Mbps
Also available with licenses limiting maximum channel bandwidth
LATENCY 1 – 3 ms one-direction latency
QoS 8 Queues
PACKET CLASSIFICATION Layer 2 and Layer 3 IEEE 802.1p, MPLS, Ethernet priority
PACKET PERFORMANCE Line rate ( >850K packets per second)
TIMING TRANSPORT Synchronous Ethernet; IEEE 1588v2
FRAME SUPPORT Jumbo frame up to 9600 bytes
FLEXIBLE I/O 2 x Gigabit Ethernet copper ports:
Gigabit Port 1: Data + PoE power input
Gigabit Port 2: 802.3at PoE output port
SFP port (single-mode fiber, multi-mode fiber, and copper Gigabit Ethernet options available)
T1/E1 TDM SUPPORT 8 x T1/E1 TDM (Network Indoor Unit (NIDU))
G.823-compliant timing
DC power input (compatible with AC+DC Power Injector output)
T1/E1 LATENCY (ONE WAY) 1 to 3 ms typical depending on range, bandwidth, modulation mode and number of T1/E1 ports; accurate T1/E1 latency figures can be
determined for any given configuration using the Cambium PTP LINKPlanner