User's Guide
Table Of Contents
- PTP 250 User Guide
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1: Product description
- Chapter 2: Planning considerations
- Chapter 3: Legal information
- Chapter 4: Reference information
- Chapter 5: Installation
- Chapter 6: Configuration and alignment
- Chapter 7: Operation
- Chapter 8: Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance in the ODU cable
- Testing the radio link
- Testing link end hardware
- Glossary
PTP 250 User Guide
phn-2182_003v004 (Oct 2011)
UNDER DEVELOPMENT
I
Glossary
Term Definition
ARP Address Resolution Protocol
ATPC Automatic Transmit Power Control
BPSK Binary Phase Shift Keying
CAC Channel Availability Check
CSP Critical Security Parameter
DC Direct Current
DER Distinguished Encoding Rules
DFS Dynamic Frequency Selection
EIRP Equivalent Isotropic Radiated Power
ETSI European Telecommunications Standards Institute
FAQ Frequently Asked Question
FIPS Federal Information Processing Standard
HTTP Hypertext Transfer Protocol
ID Identity
IEEE Institute of Electrical and Electronic Engineers
IP Internet Protocol
ISM Industrial Scientific and Medical
ITPE Initial Transmit Power Estimate
LAN Local Area Network
LOS Line-of-Sight (clear line-of-sight, and Fresnel zone is clear)
LPU Lightning Protection Unit
MAC Medium Access Control Layer
MDI Medium Dependent Interface
MDIX Medium Dependent Interface Crossover
MIB Management Information Base
NLOS Non-Line-of-Sight