User's Guide

PTP 250 User Guide Restoring, resetting and rebooting
phn-2182_003v004 (Oct 2011)
UNDER DEVELOPMENT
7-25
Resetting to default configuration (without country reset)
Use the Save & Restore page to reset the unit to factory default configuration, without
resetting the country of operation (selected at first login).
When the unit is reset to default configuration, the current configuration is lost and the
unit reboots, causing loss of service.
To reset the unit to factory default configuration, including reset of the country that was
selected at first login, follow the procedure in Resetting to default configuration (with
country reset) on page 7-26.
To reset to default configuration without country reset, proceed as follows:
1
Select menu option Configuration, Save And Restore. The Save & Restore
page is displayed (Figure 6-25).
2
Select Reset to Default Configuration and Yes to confirm.
3
Wait for at least 45 seconds.
4
The unit should now be reset to partial factory default settings, including the
following:
Password ‘motorola’,
IP address ‘169.254.1.1’,
Master Slave Status ‘Slave’.
The Country Code (selected at first login) remains unchanged.
5
To reconfigure the unit, follow the instructions in Connecting to the unit on
page
6-3 and Using the installation wizard on
page 6-13.
When logging into the unit, change Password (this will be prompted).