User's Guide
Table Of Contents
- PTP 250 User Guide
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1: Product description
- Chapter 2: Planning considerations
- Chapter 3: Legal information
- Chapter 4: Reference information
- Chapter 5: Installation
- Chapter 6: Configuration and alignment
- Chapter 7: Operation
- Chapter 8: Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance in the ODU cable
- Testing the radio link
- Testing link end hardware
- Glossary
PTP 250 User Guide Aligning antennas
phn-2182_003v004 (Oct 2011)
UNDER DEVELOPMENT
6-29
Disarming the units
When antenna alignment is complete, both units in the link must be disarmed before
network connection.
To disarm the units, select menu option Installation Wizard. The Step 5: Confirm
Configuration page is displayed (Figure 6-13). Select Se
t Disarmed, Yes to confirm and
then Back until the Step 1: LAN Configuration page is displayed.