User's Guide
Table Of Contents
- PTP 250 User Guide
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1: Product description
- Chapter 2: Planning considerations
- Chapter 3: Legal information
- Chapter 4: Reference information
- Chapter 5: Installation
- Chapter 6: Configuration and alignment
- Chapter 7: Operation
- Chapter 8: Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance in the ODU cable
- Testing the radio link
- Testing link end hardware
- Glossary
PTP 250 User Guide Using the installation wizard
phn-2182_003v004 (Oct 2011)
UNDER DEVELOPMENT
6-13
Using the installation wizard
Perform this task to configure the LAN, wireless, date and email attributes of the unit.
This task consists of the following procedures:
• Starting installation wizard on
page 6-13
• Step 1: LAN configuration on pa
ge 6-14
• Step 2: Wireless configuration on
page 6-16
• Step 3: Date and time settings on pag
e 6-18
• Step 4: Email configuration on
page 6-21
• Step 5: Confirm installation configuration on
page 6-22
Starting installation wizard
To start the installation wizard, select menu option Installation Wizard. The response
depends upon the state of the unit:
• If the unit is armed for alignment, the Step 5: Confirm Configuration page is displayed
(Figure 6-13). Select Set Disarm
ed, Yes to confirm and then Back until the Step 1:
LAN Configuration page is displayed.
• If the unit is not armed, the Step 1: LAN Configuration page is displayed.
Figure 6-13 Step 5: Confirm Configuration page (when unit is armed)