User's Guide
Table Of Contents
- PTP 250 User Guide
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1: Product description
- Chapter 2: Planning considerations
- Chapter 3: Legal information
- Chapter 4: Reference information
- Chapter 5: Installation
- Chapter 6: Configuration and alignment
- Chapter 7: Operation
- Chapter 8: Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance in the ODU cable
- Testing the radio link
- Testing link end hardware
- Glossary
PTP 250 User Guide Preparing for installation
phn-2182_003v004 (Oct 2011)
UNDER DEVELOPMENT
5-3
Selecting installation options
Use the installation report to determine which installation options are required. Refer to
PTP LINKPlanner on
page 2-10
Preparing personnel
IN NO EVENT SHALL MOTOROLA SOLUTIONS, INC. BE LIABLE FOR ANY INJURY TO
ANY PERSONS OR ANY DAMAGE CAUSED DURING THE INSTALLATION OF THE
MOTOROLA PTP 250.
Ensure that only qualified personnel undertake the installation of a PTP 250 link.
Ensure that all safety precautions can be observed.
Preparing inventory
Perform the following inventory checks:
• Check that an installation report is available and that it is based on the principles
described in Chapter 2: Planning considerations.
• Check
that the correct components are available, as described in Ordering components
on page 2-24.
• Check
the contents of all packages against their packing lists.
Preparing tools
Check that following specific tools are available, in addition to general tools:
• 13mm wrench and 22 mm wrench for use with the glands.
• RJ45 crimp tool (it must be the correct tool for the type of RJ45 being used).
• Personal Computer (PC) with 1000BaseT Ethernet.
• Web browser (for example Internet Explorer 7, Internet Explorer 8, Firefox 3 or Firefox
3.5).
• Ethernet patch cables.