User's Guide
Table Of Contents
- PTP 250 User Guide
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This User Guide
- Chapter 1: Product description
- Chapter 2: Planning considerations
- Chapter 3: Legal information
- Chapter 4: Reference information
- Chapter 5: Installation
- Chapter 6: Configuration and alignment
- Chapter 7: Operation
- Chapter 8: Troubleshooting
- Testing link end hardware
- Testing when PoE LEDs do not illuminate correctly
- Testing after a lightning strike
- Test flowcharts
- AC LED is off
- AC LED is flashing
- PORT LED is off
- PORT LED is flashing
- Test Ethernet packet errors reported by ODU
- Test Ethernet packet errors reported by managed switch or router
- Test ping packet loss
- Test resistance in the ODU cable
- Testing the radio link
- Testing link end hardware
- Glossary
PTP 250 User Guide Notifications
phn-2182_003v004 (Oct 2011)
UNDER DEVELOPMENT
4-17
Norway regulation is FOR2007-04-20 Nr 439 regarding border PFD limit.
This equipment operates as a secondary application, so it has no rights against harmful
interference, even if generated by similar equipment, and must not cause harmful
interference on systems operating as primary applications.
Hereby, Motorola Solutions, Inc. declares that the PTP 250 products comply with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
The declaration of conformity
may be consulted at http://www.motorola.com/ptp/support
.
The European R&TTE directive 1999/5/EC Certification Number is reproduced on the
product label (Figure 4-3).
Figu
re 4-3 European Union certification on 5.8 GHz product label
The PTP 250 connectorized products have been notified for operation in those EU
countries that allow 5.8 GHz operation.